honeywell issue
Thread Content
I would like to ask: 1. Is the DATAACQ Block a regular display module? Is this module necessary in a regular control loop? So, there must be a DATAACQ module between the PID module and the AIchannel module to establish a connection, right? 2. How to create a new point selection within a drawing? Since some modules are not in the same drawing, it is necessary to establish connections – how does one do that?
Data is used to set the range, units, small-signal rejection, and so on for your table; the most important aspect is still the range. 2. Just hold down the module and drag it into point
So can’t PID module 9 be set?