How to check the magnet in a magnetic pump
Thread Content
After the magnetic pump starts operating, how can one check whether its magnetic properties meet the specified requirements?
Magnets are generally made of permanent magnetic materials; as long as the medium does not overheat and there is no idle rotation, there are usually no problems
Check whether the traffic can meet the parameter requirements. Personal opinion. .
When maintaining the pump, just remove the inner and outer magnets and use a torque wrench to check the torque. . . Keep using it if it meets the requirements. . Otherwise, it’s time to replace the parts
Demagnetization should result in a decrease in flow rate, until it becomes so low that it can no longer meet the requirements for use. Generally, demagnetization occurs when pressure builds up at the pump outlet, causing the magnetic field lines to be interrupted; under normal operating conditions, there should be no problem……
The magnetic pump purchased by our factory from Hyland – can identical type of isolation sleeves and sliding bearings be found from other manufacturers?
For isolation sleeves and sliding bearings, it’s better to buy the original ones. The original version is too expensive?
Yeah, the manager is checking to see if there are any other factories that offer lower prices. Can sliding bearings be purchased from other factories?