Help: How to create labels and mark zones for a new factory?
Thread Content
I would appreciate some advice from experts: The new factory is about to be completed, and I need guidance on how to install safety signs in the factory, as well as on how to divide the areas and mark them with lines What criteria should be used? Thank you
Ground passage lines, area demarcation lines 1) Line type Class A–solid line painted in bright yellow, line width 60 mm: Used in principle as lines for locating items； Line width 80mm: Used in principle for lines in the equipment area ； Wire width 120mm: Used for main channel wires in principle. Legend: Category B – dashed lines in bright yellow paint, line width of 60 mm: division lines within large work areas, as well as pathways that allow passage (can be a combination of solid and dashed lines) ； Legend: Category C – red solid line with a width of 60 mm: the boundary line for the area where defective items are placed (a red solid line is drawn on the ground at the side facing the third wall) ； Legend: Class D – Diagonal zebra stripes composed of bright yellow and black (at 45º angle); lines marking hazardous material areas, warning areas, and fire exit routes ； Legend: Class E -- Green solid line; demarcation lines for the area where qualified products are stored and pathways in the finished product warehouse ； Legend
The sofa has covered everything very comprehensively； We have also installed clear signs at the entrance to the production area ； Design walking paths on both sides of the main road ；