Cold salting out overflow belt material!
Thread Content
I would like to ask everyone: first, there is material overflowing from the cold crystallization vessel, and then it happens with the salt crystallization vessel as well. How should this be adjusted? I hope everyone can offer suggestions!
This post was last edited by mkp369 on 2017-1-6 at 15:40: 1. Control the amount of salt added, maintain the appropriate Na+ level for half-MII, and pay attention to the solid-liquid ratio in the cold precipitation process. 2. Coordinate the amount taken out with the centrifuge to prevent the formation of cold, thick material bands. 3. Check for crystal leakage in the centrifuge filter screen.
Check whether excessive alkaline substances have been carried into the crystallizer
What is the indicator for alkaline substances?
This post was last edited by mkp369 on 2017-2-15 at 13:59. Control the amount of salt added, maintain the Na+ level at half MII, and pay attention to the solid-liquid ratio in the cold precipitation process