Alignment of tower equipment
Thread Content
How is the tower equipment aligned? If alignment is achieved using shims, embed iron pieces in the foundation. So how should the embedded iron be designed? 1. Are the embedded iron pieces and the tower skirt base plate designed as a pair? 2. How should the anchor bolt holes on the embedded iron be designed? 3. What should be the thickness of the embedded iron? 4. What are the steps for aligning with shims? 5. It would be better if a few simple diagrams could be provided. Those who are experienced in foundation work or installation, please give some advice.
The foundation of tower equipment usually does not have embedded iron; instead, inclined iron bars are placed between the concrete foundation and the tower base.
What if we use embedded iron? Are there any design standards for embedded iron?
Those with embedded iron are usually not towers; they are small, low-profile devices, and the device base can be welded to the embedded iron points.
What if we set the embedded iron according to the requirements now? Can the embedded iron be designed as a ring similar to the skirt base?
Embedded iron pieces can be used, and these pieces must follow the same template as the skirt base and formwork, so as to ensure no problems occur during installation.