When using pdS to delete fittings, only the center line can be removed; the outer surface of the pipe cannot be deleted. Could you advise on how to resolve this issue?
Thread Content
When using pdS to delete fittings, only the center line can be removed; the outer surface of the pipe cannot be deleted. Could you advise on how to resolve this issue?
This post was last edited by chiren on 2016-11-17 at 15:55. I haven’t encountered that issue; first check for errors, such as residual center lines or overlapping center lines
I also think it might be residual center line, but I’ve checked and there’s no error
One can only search little by little by eye; this is quite troublesome. Click on the double bonds in the vicinity at random to see if it’s possible to click on them
Such errors only occur occasionally, I guess. PDS still has some bugs; if the unwanted outer layer cannot be removed, use the command for deleting pipe fittings to get rid of it. If that doesn’t work either, go to the shared folder, find the model file, and use the MicroStation command to delete it. It’s fine to do this occasionally. After deletion, run a Reference Data Conflict Report to check and fix errors