Support installation for inlet and outlet pipelines of reciprocating compressors
Thread Content
This post was last edited by sue211 on 2017-5-17 at 14:34. The regulations state that \"the foundations of the support structures for the inlet and outlet pipes of large and medium-sized compressors should be separate from the foundation of the factory building.\" ” If the foundations of the pipe supports at the compressor’s inlet and outlet are located below the foundation of the factory building, but are not connected to it. For example, the foundation of the compressor is at -2 meters, while the foundation of the pipe supports is at -1 meter. Is it feasible to do this?
I’m not particularly familiar with this area; I’m not sure. I’ll wait for answers from other sea travelers
I think it’s feasible; the separation specified in the guidelines is to avoid them being connected together, which would prevent the pipe rack from functioning properly.