Regarding the interception area
Thread Content
Gentlemen, our company has a DN400 filter, which contains 5 magnet rods with a diameter of Φ45. These rods are arranged with 2 at the top, 2 at the bottom, and 1 in the middle. It is used to remove iron slag from within pipes. The concentration of the medium in the pipes is 10%, the pressure is approximately 0.4 MPa, the flow rate under operating conditions is 13,000 l/min, and the flow velocity is 1.3 m/s. I want to know whether the cross-sectional area through which the medium flows into the filter is affected. How should it be calculated? Seeking advice from experts
There should be no impact; the filter itself occupies space, and the area occupied by the magnet rod does not result in as much loss of space as the filter does.
Does no one know it’s that deep?
Are there so many experts because my questions are too difficult to understand, or is it that no one replies?