Are the actuators for the pneumatic control valves DN20 and DN25 of the same model?
Thread Content
This post was last edited by FORREST_GUMP on 2021-11-1 at 15:17. There are two pneumatic control valves with the same operating conditions, but different diameters: DN20 and DN25. Are the actuators used for these two valves of the same model? Or in other words, is there a significant price difference between DN20 and DN25 pneumatic control valves?
With the same operating conditions, the same type of actuator can be used, and the price difference is likely to be minimal.
These two prices can be the same, as long as the buyer isn’t too picky
The thrust of these two bore sizes differs little, so the same type of actuator can be used
Thank you. In terms of manufacturing processes, DN20 and DN25 are used in similar ways, and the price difference is not significant; so I’ll go with DN25:lol
Thank you, then I’ll give priority to DN25
The operating environment, pressure difference before and after, and sealing requirements are similar; the actuators can be interchangeable, and the prices are roughly the same； The locator varies depending on the price ；