How to prevent bolts inside the mixing tank from falling off
Thread Content
How to prevent bolts inside the mixing tank from falling off
Lock it in place using two nuts (one turned clockwise and the other counterclockwise).
If it’s not a dead corner, it can be welded in place. When disassembly is needed, a chisel or an electric grinder can be used to remove it. For reference.
After the screws are tightened, spot weld them in the appropriate positions.
It is also possible to drill a hole at the end of the screw and insert an opening pin；
Spot welding, though a rough method, is simple and reliable
Capping, welding, anaerobic adhesives – there are countless methods.
Weld it in place without removal； If disassembly is required, use two nuts (one turned clockwise and the other counter-clockwise) to lock it in place
That’s indeed the case, but the bolts need to be replaced every time