English — Forum #279 (Page 30/30)
- We are in urgent need of a gas preheater; the technical requirements are as shown in the figure below. Everyone, - HCBBS Forum
- What’s going on with the suggestions regarding the sw6 design tube sheet? - HCBBS Forum
- How to prevent freeze damage in heat exchangers during winter - HCBBS Forum
- What type of heat exchanger is this? - HCBBS Forum
- Have you all heard about the effect of foaming inside heat exchangers on the heat exchange area? - HCBBS Forum
- Corrosion protection of tube sheet in shell-and-tube heat exchangers (methyl chlorides) - HCBBS Forum
- A simple method for determining the heat transfer area of shell-and-tube exchangers in process design - - HCBBS Forum
- Heat exchanger - HCBBS Forum
- Correct disassembly and repair procedures for heat exchanger plates - HCBBS Forum
- Drier - HCBBS Forum
- There is vibration in the inlet and outlet tube bundle areas of the heat exchanger - HCBBS Forum
- Can a fixed-tube-sheet heat exchanger be manufactured in two or more parts? - HCBBS Forum
- Dual-arch baffle - HCBBS Forum
- Temperature difference correction factor for single-pass cross-flow heat exchangers when there is no lateral mixing between the hot and cold fluids - HCBBS Forum
- Regarding the lead plates for pressure testing heat exchangers - HCBBS Forum
- How are the heat exchangers below classified? - HCBBS Forum
- Determining the model of a heat exchanger from its appearance - HCBBS Forum
- Bevels on both sides of the tube holes in the heat exchanger tube sheet - HCBBS Forum