When acid is absorbed, the surface level drops
Thread Content
What is the reason why the acid concentration is 98.5% when production is stopped, but drops to 81% (on the surface) when production resumes after a week? The outlet of the suction pump has also been corroded; there’s a lot of black acidic sludge. I’d appreciate some advice
I’m curious how the surface acid concentration of 81 was determined
I’m curious how the surface acid concentration of 81 was determined
I’m curious how the surface acid concentration of 81 was determined
It is likely that the dilution water valve in the suction circulation tank is not closing properly, which is causing this issue
When the unit is shut down for an extended period of time and no regular cycling takes place, low-concentration acids that absorb moisture accumulate in the tower. It is necessary to replace these acids promptly, conduct analyses, or carry out periodic testing and acid replacement; otherwise, the pumps may be corroded. Generally, the acid concentration changes significantly after a shutdown of 3 days or more, and this problem is even more severe when the tower is not sealed, so it requires close attention.