What are the requirements for the installation angle of vertical cycloidal pinwheel reducers?
Thread Content
What are the requirements for the installation angle of vertical cycloidal pinwheel reducers? For example, for those on top of the reaction tank, how is it detected? Is a level used to check the levelness, or is a plumb line used to measure the side distance? What are the specific numerical requirements? Are there any standards that can be referred to?
The end face of the base is measured using a level, with the requirement being in line with the installation specifications for the moving equipment.
This post was last edited by jmdc on 2017-7-12 at 14:39. The surface area at the base of the frame is too small; it’s likely not possible to place a level there (see the photo below – which surface is indicated by the arrow?). How do I upload photos when replying to a post? And what is the required level of accuracy?
A level can be placed on the flange of the reducer; when installing the reducer, it is required that the centerline of the output shaft aligns with the centerline of the mixer!