Regarding the modification of the secondary seal air system in centrifugal compressors
Thread Content
Since low-pressure nitrogen sometimes fails, to ensure the proper operation of the centrifugal compressor, the isolation gas can be replaced with factory air. It would be useful for everyone to discuss how the secondary sealing gas should be modified to meet the requirements.
Take a look at API614 – it contains requirements; there are specific specifications at least regarding pressure, dew point, flow rate, and the way in which the process should be set up!
Take a look at API614 – it contains requirements; there are specific specifications at least regarding pressure, dew point, flow rate, and the way in which the process should be set up!
Additionally, it depends on the medium used in the compressor; air must not contaminate the medium or pose a risk of mixed explosions, which is why hydrogen compressors are not suitable.
The 5th floor is the correct choice. Additionally, if the risk is not high, it’s essential to install a fine filter (set)~~~