Steam compressor
Thread Content
Hello, experts. What causes the pressure ratio and temperature rise of high-speed motor-driven steam compressors to not meet the design requirements? Everyone is welcome to provide their analysis
That’s a bit too general; could you be more specific?
If this issue arises during acceptance, it should be resolved by the equipment manufacturer. If it occurs the day after tomorrow, it will be necessary to provide information on how it changed at the time the problem occurred, as well as the relevant data and phenomena.
It’s a bit vague – is it piston-type? Or other structural forms? ?
Hello! It’s a centrifugal steam compressor driven directly by a high-speed motor; after it was started, it was found that both the temperature rise and pressure ratio did not meet the design specifications. I’m not sure what is causing this problem Provide some analytical comments
There’s a problem with the design; the pressure ratio can’t be increased, so the temperature rise definitely won’t increase either
Have the manufacturer check whether it has reached the rated speed.
Hello, may I ask which manufacturer’s motor is being used? Is there a problem with the design? I hope to get in touch with you