【Mechanical Equipment Technology Exchange Edition】Mechanical Equipment 【Daily Question】20201209

Thread Content

This post was last edited by wyr261 on 2020-12-13 08:05. During the alignment of the pump and motor couplings, the dial gauge was fixed to the pump body; the reading on the radial gauge was 0, while the lower reading was 0.20. The reading on the axial gauge was 0, with the lower reading being -0.30. From the above readings, it can be known that: (B). (The comparison of heights refers only to the axial position at the outer diameter measurement points.) A. The pump is higher than the motor, with an upper opening; B. The pump is higher than the motor, with a lower opening; C. The pump is lower than the motor, with an upper opening; D. The pump is lower than the motor, with a lower opening. For the daily question activity in the Mechanical Equipment section, please reply within 3 days.:victory: Rewards range from 5 to 15 points depending on the response; those who can provide detailed answers will receive additional rewards. All forum members are welcome to participate actively and help promote the development of the forum! ! !