May I ask if there are any issues with this bearing bush that relate to the colored area, in terms of whether it meets the standards?
Thread Content
May I ask if there are any issues with this bearing bush that relate to the colored area, in terms of whether it meets the standards?
It’s not determined based on the colored area to see if it complies; specific points need to be considered. Then, the gap of the upper cover is measured using various methods, and the gap is adjusted in accordance with relevant requirements. For reference.
There are concerns about potential issues, so material certificates, dimension drawings (to check whether all dimensions are within the acceptable range), and so on are required. Additionally, there is the issue of gaps (which is very important for installation)； It’s impossible to tell just by looking; any issues can only be detected through measurement and use
The contact area needs to be considered, as well as the contact points; there are issues with the oil inlet wedge section
Chamfer it, so the lubrication is better.