Issues with saddle data in the new support standards
Thread Content
The new version of the support standards has been received; I just took a quick look at them, and it turns out that there are only 3 bolt holes in the anchor series DN2100-4000. . . .
The standard has not been obtained yet; I’m not sure what the original poster is referring to
What does it mean that there are 3 anchor bolt holes as shown in the diagram?
Last edited by yzwanfu on 2018-7-7 16:17: View the cross-section in halves to see the 4 bolt holes with a diameter of over 2900
As can be seen from the diagram, the left view refers to those with two anchor bolt holes, while the right view refers to those with four anchor bolt holes; there is no such thing as three holes.
I’ve learned it.* The new standard is about to be available.
At first glance, it seems to be 3, but upon closer inspection, the smaller ones are 2 and the larger ones are 4.