Thread machining
2019-09-30View Original
Thread Content
How is the tap clearance groove for internal threads machined?Reply #22019-09-30
Machined on a lathe using a turning tool
Related Threads in This Forum
← Previous
- Gravity balance mechanism - HCBBS Forum
- Flat cover opening reinforcement calculation - HCBBS Forum
- Cracks occurred in the base material of the lower part of th
- 6 steps for on-site fault vibration analysis - HCBBS Forum
- Requirements for cryogenic insulated containers under the ne
- What do these symbols in the assembly diagram mean? Thank yo
- Can an elbow be welded directly to the cylinder? - HCBBS For
- Who has the electronic version of the \"Code for Constructio
- Asking a senior for advice on gas tank standards - HCBBS For
- Do the tie rods of the expansion joint need to be removed? -
Next →
- Help: Welding Handbook, 3rd Edition, 2017 version - HCBBS Fo
- The welding process was not interrupted, but is a reevaluati
- Effect of common chemical elements on the properties of cast
- Material and type of boiler evaporator - HCBBS Forum
- Issues with welder qualifications for welding the cylinder t
- Regarding the issue with activated carbon filters - HCBBS Fo
- For a styrene storage tank with a capacity of 2,000 cubic me
- Questions regarding the use of ASME materials as materials f
- Does wind stability calculation for large storage tanks need
- How to proceed with shutting down a spherical tank that has
Translated at 2026-07-21 02:55:27
Original: https://bbs.hcbbs.com/thread-2790489-1-1.html
© 2026 HCBBS Forum. Content translated for international readers.