I couldn’t find a wound gasket with inner and outer rings for DN40 CL300 in the warehouse, so I used a wound gasket for DN40 CL600 as a substitute – will that work?
Thread Content
I couldn’t find a wound gasket of DN40 CL300 with inner and outer rings in the warehouse, so I used a wound gasket of DN40 CL600 as a substitute. Will that work? Please give me some advice, experts. . :lol:lol:lol
It can be used; those with a higher pound rating can replace those with a lower pound rating, in other words, a higher rating can be used in place of a lower one.
It depends on whether the sizes of the sealing surfaces of the two are the same. As long as the sizes are the same, that’s fine!
The dimensions of the sealing surfaces are different; in particular, the outer edge is larger, which affects the installation of the bolts
The one with an outer ring seems to have a larger outer edge, and in the end it simply can’t be tightened properly
Well, what a careful person; the sealing surfaces of flanges with small diameters are the same