Are there any experts online who know about A2 pressure vessels and the pressure range for which they can be used in manufacturing?
Thread Content
Seeking help as stated in the title: A2 pressure vessels, the pressure range suitable for their manufacture. The key is the pressure range: whether only values in the range of 1.6 ≤ P ≤ 10 MPa can be produced, or if pressures above 10 MPa are also possible
A2 allows the manufacture of high-pressure vessels with a diameter of less than 2000 (the pressure range for such vessels is specified in relevant regulations)
This post was last edited by zjq1962 on 2021-11-20 at 09:42. A2 can be used to manufacture high-pressure vessels with a diameter of less than 2000 (the pressure range for high-pressure vessels is determined according to relevant regulations). In terms of pressure, it’s possible to manufacture vessels rated for pressures below 100 MPa.
Alas, laymen managing experts – TSGR1001 is clear and straightforward, but then a layman’s organization creates TSG07, turning things into a mess that’s confusing and unclear.
Under the new regulations, for medium and low-pressure vessels, D applies; only high-pressure vessels with a diameter of no more than 2000 MM are classified as A2