Tube sheet calculation
Thread Content
In SW6, when calculating the tube sheet, there is an area for the partition groove – where does this value come from?
Is this value the internal diameter of the device multiplied by the groove width?
151, there are calculation formulas on page P77
It’s not that one. Then which one does the original poster think it should be? !
Should it be the inner diameter multiplied by the groove width?
If I remember correctly, your figure is 1440; that can’t be right, right? It can’t be this small, right?
The value calculated for the baffle groove using the method you mentioned, as well as the calculation method specified in GB/T151, has little impact on the thickness of the tube sheet; however, the method you mentioned is incorrect.
Actually, I draw them every time, because it’s fine for two pipelines, and it’s even faster to draw those with four pipelines.
http://bbs.hcbbs.com/forum.php?mod=image&aid=1269007&size=300x300&key=955c27c63dcd8fa4&nocache=yes&type=fixnone