Thread Content
1. The relationship between the diameter of the drive drum of a plastic chain conveyor and the belt fabric layer, the matching of the drive drum and the direction-changing drum, as well as the requirements for the groove angles of the idler rollers, should all be selected reasonably in accordance with the design specifications of the conveyor. 2. The feeding direction of the plastic chain plate should be in line with the running direction of the belt; in order to reduce the impact of falling materials on the belt, chutes should be used to shorten the falling distance of the materials. 3. The operating speed of the belt driven by the plastic chain plate should generally not exceed 2.5 meters per second. For materials with large particle sizes and high wear resistance, as well as in cases where fixed discharge equipment is used, it is advisable to opt for a lower speed. 4. The type, structure, standards, and number of layers of the plastic chain plate used for transporting tape should be selected appropriately based on the operating conditions. away ； In the tape receiving section, the spacing between idlers should be reduced, and buffer idlers should be used to prevent leakage of material. A flexible yet appropriate baffle should be selected for the belt to avoid the baffle being too hard and scratching the surface of the conveyor belt. 5. During storage, plastic chain plates should be kept in rolls, without being folded; they should be turned over once per quarter during storage. 6. During transportation and storage, plastic chain conveyor belts should be kept clean, protected from direct sunlight or exposure to rain and snow, prevented from coming into contact with acids, alkalis, oils, organic solvents, etc., and kept at a distance of one meter from heat-generating equipment. 7. When storing plastic chain plates, the warehouse temperature should be maintained between 18-40 ℃, while the relative humidity should be kept between 50-80%.