Installation direction of Y-type filter
Thread Content
Dear sea friends, how are the Y-type filters of your company usually installed? Horizontal or vertical? Is there any specification regarding whether a horizontally installed Y-type should point downward (to a lower point), sideways (at the same level), or at an angle downward (inclined)? My previous companies used vertical designs; later, we changed them to an inclined design for easier disassembly. But with the new company I’ve joined recently, everything is horizontal – I don’t understand why
The question raised by Ban Da should be whether the position of that Y (filter screen) is vertical or horizontal, not the overall flow direction. (There will be an arrow on the device’s surface indicating the overall flow direction; please install it according to that arrow.) Basically, as long as it can perform filtering functions, that’s fine. But it shouldn’t be positioned upward; we always install it downward or horizontally… In that case, the filter screen won’t be at the lowest point, which may result in poor filtering efficiency. Alternatively, the manufacturer might have specific design requirements that dictate horizontal installation. It’s recommended to confirm this with the manufacturer again
I’ve only used it horizontally on a steamer; in all other cases it’s installed vertically. If there isn’t enough space for a vertical installation, then it can indeed be used horizontally.
It’s not a problem with the filter direction.
If it is installed horizontally, will this prevent the impurities filtered out from settling? Scouring of the filter screen, causing damage to it?
This problem exists when it’s installed facing down as well, right?
From the principle of filters, there should be no problem; at that time, *inertia acted downward
If there is a change in space during the fluid flow process (from large to small), the suspended particles inside will generally settle due to the change in flow velocity; thus, this is the main factor causing them to move downward. However, there may be cases with special designs, so it is still necessary to confirm with the equipment manufacturer