The high and low pressure sensing of the double-flange level gauge is reversed
Thread Content
This post was last edited by Time passes by on 2018-4-15 05:37. The high-pressure side of the double-flange level gauge is installed at the top, and the low-pressure side is also installed at the top; can I reverse the upper and lower limits as well?
The key is whether the transmitter has experienced negative drift The measurement range includes the possibility of performing such measurements as well. But changing the interface isn’t that difficult either; it makes it easier to maintain things once they are standardized, right?
Let’s change it; it’s not that much trouble at all, so why bother?
You’ve installed both high and low pressure systems on it – use it for swinging! It is said that for some brands, if anti-tampering measures are in place, it is possible to make adjustments in the software; however, after such adjustments, accuracy is no longer guaranteed. Most brands do not allow it. Let’s change it
No, it’s troublesome; switch it around instead