Please, expert, design a circuit diagram in which the pump stops and the electric ball valve in the hot water pipeline opens automatically
Thread Content
The pump used for transporting materials is automatically controlled to start and stop using a float switch. I now want to add a hot water pipeline to the delivery system, so that the pipeline can be cleaned with hot water every time the pump finishes transporting material. Could someone with expertise in electrical circuits design a circuit that allows the electric ball valve on the hot water pipeline to open automatically when the pump stops, and that also enables the valve to close at a set time? If an air compressor pipeline is added as well, so that air is supplied after the hot water has been used, can such a circuit be created? Please ask an expert for help, thank you.
To celebrate National Day, get some money and buy a picture......
It’s simple, right? Just find any factory electrician, that should do it...
This is too simple – just connect the pump shutdown signal to a relay to control the ball valve, and add a timer as well
The electric ball valve is activated by determining the current or frequency, or by checking the status of the contactor.
The ball valve is set to open when a signal is received and to close when the signal is lost; the signal is taken from the relay auxiliary contact of the pump