What is the difference between the transmitter block range and the output range?
Thread Content
When setting the range to 475, are there two range settings? Which one is usually set? What’s the difference between the two?
The loose block range is the measurement range, while the other one is the output range; these two must correspond to each other, otherwise the display on the gauge will not match the display on the DCS
This post was last edited by 1111111 on 2018-10-22 21:24: Transmitter range, output range? ,,., Hahaha, that’s the stupidly distorted mouth of that dog – it’s a translation. . . Pulling away to feed the dog is nothing. :Lol, the so-called range of the transmitter block refers to the rated range, the nominal range, or the inherent range of the sensor itself – for example, 0–1 MPa. As for the output range, it refers to the operating range, the range in which it is used, and it corresponds to the 4–20 mA signal; for instance, 0–0.5 MPa, 0.1–0.5 MPa, and so on. The operating range can be set anywhere within the rated range. Do you understand?
There is a relationship of inclusion and being included, right\ud83d\ude04?