1131 Internal variable
Thread Content
Are these variables considered feedback? How can I find the source of this variable using 61430?
This post was last edited by chensf123 on 2018-10-23 at 23:07. This signal is not necessarily a real-time feedback signal; it could be another point derived from the program’s solenoid valve control logic, that is, an internal variable, which is used for data conversion here. You can search using “Find All” or in the configuration.
Got it; it was a computer issue yesterday, and now the address is showing
How would you like to adjust it? This module outputs a \"1\" signal when the output of your transmitter exceeds the upper or lower limits (3.8–21 mA), such as in the case of an open circuit, thereby indicating a fault with the temperature sensor or the temperature-related components.
Is it just for detecting faults? I thought it was used to set the calibration current and range. My apologies
Is it just for detecting faults? I thought it was used to set the calibration current and range. My apologies
Also, I know the tag number; how can I quickly find the corresponding control block?
The 1131 software has a search function; by entering the corresponding tag number in the search field (the * wildcard can be used), the relevant tag number can be found.
This software has simulation capabilities. Are you not familiar with it?