Please give this pressure measurement device system with dual card-slot connections a try and see how it works
Thread Content
Our client developed a dedicated system for conducting experiments on their company’s products. Please take a look and see what you think of the layout
It’s for exercising the lumbar spine, right? Look down – no, you need to crouch down to see it; oh, now I can see it clearly ； Look up – no, I need to stand on a stool to see it; oh, now I can see it clearly.
It’s quite standard; it should belong to the high-pressure category
This post was last edited by 1111111 on 2019-10-19 at 20:34. It looks pretty good; it’s attractive and suitable for use in product displays. It’s a bayonet connection, and the pipe isn’t thick, which makes it difficult to disassemble and reassemble the meter repeatedly; after just a few attempts at disassembly, air leakage might occur. :lol It would be better to add a clip somewhere under the meter’s connector to prevent the pipe from moving. If no reinforcement is used, using a wrench to remove the meter is likely to cause problems.