AB Rockwell MACSV6.5.4 installation issues
Thread Content
After completing the installation of Allen-Bradley MACSV6.5.4, I found that the optical drive and extra USB ports were disabled; once they were enabled, they were disabled again automatically. What should I do? Thank you
When encountering this problem, you can try the following steps: 1. Check whether there are any system policies or security software settings that automatically disable the optical drive and USB during installation. 2. Update or reinstall the drivers for the USB and optical drive. 3. Check the settings of MACSV6.5.4 to see if there are any options for controlling the activation status of hardware devices. 4. If the above methods all fail, you can try contacting Rohde & Schwarz’s technical support for help. I hope this can help you! .
This is set by the Allen-Bradley software itself; it will be automatically disabled again whenever the computer is shut down and restarted
If the project has been backed up and there’s no USB port, then how was it exported?
Temporarily enable the USB port – 10 minutes is enough!
This is set by the Allen-Bradley software itself; it will be automatically disabled again whenever the computer is shut down and restarted. You can right-click on the green control icon in the lower right corner of the computer, select Settings, and then adjust the time