INTECONT PLUS mass flow feeder
Thread Content
INTECONT PLUS mass flow feeder – I’m not sure if any of the users here have used it, so I hope we can exchange our experience regarding its use. After I reset this mass flow meter, it can no longer be used – the dots on the display panel no longer move. I hope HAIYOU can provide some help and suggest a solution; it’s urgent.
No one replied:( I concluded it myself: The possible reasons for no rotation are: 1. The feeder is not turned on; 2. The wheel is not turned on; 3. No rotation speed is detected at the site – the speed sensor is damaged; 4. For other faults, refer to the manual using the fault codes.