The liner ring hangs down and rests on the quenching ring
Thread Content
One section of the liner ring hangs down over the quenching ring; it is approximately 50 cm in length and 15 mm thick, with significant thinning, while the thickness of the other parts is 40 mm, with the original dimension being 67.5 mm. What could be the reason for such severe thinning in just this area? Is it the thinness that causes softening and sagging? Thank you
What’s the condition of the slag outlet at the location where your liner has thinned? What’s the situation with the lower quenching ring and the downcomer?