We adopt a partial combustion process flow
Thread Content
This post was last edited by liaifeng on 2018-7-28 07:43. What can be observed on the DCS interface regarding the air supply volume for the sulfur recovery Claus furnace?
This post was last edited by sdwfsgyykai on 2018-6-12 08:43. I don’t understand – what should you understand first? Please describe the problem in detail; otherwise, no one will be able to help you.
Under normal circumstances, if the air supply is high, the furnace temperature should be higher, and the ratio will show a negative value!
This post was last edited by sdwfsgyykai on 2018-6-13 08:04; two acidic gas pipelines are shown on the Partial Combustion DCS. Oxygen supply is the same; there’s no difference.
Okay, thank you. What I want to know is: what changes will occur through the operation interface when the air distribution is increased but the ratio meter malfunctions? What phenomena are there? For Claus reactors.
Compared to normal air supply, the combustion reaction temperature rises, the Claus reaction temperature drops, and SO2 levels exceed the limits.
Do you have contact information? Message me privately and I’ll give you the operating procedures
Let’s chat privately; I’ll send you my operating procedures