【Hysys】Why is the difference in the gas-liquid flow rates through the tray so large when two files with exactly the same input values are used?
Thread Content
This post was last edited by longkui1990 on 2017-12-11 at 17:41. The tolerance values have been reduced by a factor of 10, yet the cause of this difference has still not been identified. I would appreciate it if someone could give some guidance. O(∩_∩)O Thank you. Please find the two files for version 8.8 in the attachments
The reflux ratio and reboil ratio are different, and at the same time the net feed flow rate is also different? Could you check that?
Take a look and see if the content you specified at 0.99 is the same, haha
The eyes are blind. . Thank you, great master. .