7.6-meter-diameter composite plate head
Thread Content
The composite plate head has a diameter of 7.6 meters; its perimeter is at the lower limit of the tolerance, while the perimeter of the cylinder is at the upper limit. There are 3 amounts of misalignment when aligning the cylinder; is there any way to increase the perimeter of the head by 20 mm? Thank you!
There is a problem with the manufacturing process; it depends on the material of the lower cylinder section of the head!
If spinning is not possible (the head has already arrived), what other methods are there to increase the circumference of the head by 20 mm?
If spinning is not possible (the head has already arrived), what other methods are there to increase the circumference of the head by 20 mm?
Add a short circuit, with one end at the head circumference and the other at the cylinder circumference
Before manufacturing, you should use a long steel tape measure to measure the perimeter of the head, record that value, and then subtract the wall thickness on one side to determine the length required for cutting and rolling the cylinder. Can’t you make the current cylinder smaller?