Low-flow specialty pumps. Leakage in Tiande pump seals
Thread Content
There are two sets of seals in gsb_f_20_200, and it still leaks even after trying to install them several times
You held on to the end; today should be your last day at work. Thank you for your hard work.
Check whether there is any change in the length of the shaft sleeve, and replace the sealing O-ring
The image you sent should be of a GSB high-speed pump; are the two seals used to seal the medium and the lubricating oil respectively? Could you describe the maintenance process in more detail? Replace the entire sealing set? Replace the O-ring? Is the sealing compression amount too small?
The leakage volume is high; the white oil tank has opened and oil is spraying out
Is the flushing protocol PLAN52? Could you describe it in detail?
Why are photos always taken of the inducer wheel and impeller? Give me a mechanical seal, please!