The pump at the site has been emptied – what happens in the DCS?
Thread Content
This post was last edited by 156026692 on 2019-5-17 at 19:16. The pump on site has been emptied – are there any corresponding phenomena in the DCS?
Pressure drops, flow rate drops, power and current drops
Pressure and flow rate decrease. The current shown is also lower than the normal value
The pump does not deliver fluid, which means the flow rate decreases, the pump pressure drops, and accordingly the current also decreases
Flow rate decreases, and outlet pressure drops. There is a lot of noise and vibration at the site, and the pressure gauge shows low pressure
If we look at the DCS display, then both the pressure and flow rate have dropped. Basically, everyone upstairs has responded. Please check if the original poster still has any doubts or questions. If not, they can edit the post at floor 1 and change 【Seeking help】 to 【Solved】:lol
Pressure, flow rate, and current all decrease
The flow rate, pressure, and current have decreased; it is recommended to install low-current protection