Calculation of pressure vessel thickness
Thread Content
Help me calculate whether the wall thickness of the container is reasonable. Operating pressure: atmospheric pressure； Operating temperature: 60°. Diameter: 3400; height: 7000. The angle of the conical section at the lower end is 15°, with a thickness of 6 mm. The outlet diameter is 100 mm. The lower 3000 mm of the cylinder has a thickness of 6 mm, while the upper 4500 mm has a thickness of 4 mm. The thickness of the flat cover flange is 4 mm, and it includes reinforcing ribs in a cross-shaped pattern [16a]. Is this reasonable? Using SW6, the calculated thickness of the flat cover flange turns out to be too large. It would be great if you could help me calculate it and also explain the process to me
The material information should be provided to facilitate calculations by users.
Sorry, the material is 304 stainless steel