E+H wrap-around radar level gauge
Thread Content
Hello everyone. Yesterday, the E+H loop-type radar level gauge was showing IOP alarm from time to time. Upon on-site inspection, it was found that the screen displayed \"Fault in F272 electronic module\". Has anyone else encountered a similar issue? Is there a fault with the circuit board?
Have you tried turning it off and on again? First, perform a power-off restart; if that doesn’t work, replace it with a module of the same model – there’s no need to worry too much about it. After replacement, check whether the relevant parameters need to be reset; if it is still under warranty, send it back to the factory for repair or get a new one.
I agree with the solution suggested above. Additionally, you can try plugging and unplugging the electronic module; if that doesn’t work, it’s recommended to replace it. Check if water has gotten in due to poor sealing
Display module failure: First, check whether the contacts of the module are in good condition and there is no short circuit; you can clean the contact areas or plug and unplug the module several times to try again； Check again after resetting ； Replace this module