10° elbow
Thread Content
I need 3 elbows of 10°DN500 SCH20 for the tank area right now. Could anyone suggest what to do?
What does that mean? What should I do? Is it usable, and how to make a 10-degree elbow? If you do it, either have the manufacturer make it custom ； Either buy a 90-degree elbow and have it machined and cut into 10 degrees by an external contractor.
The strength at 90 degrees is that way; does it change just because it’s at 10 degrees? For such small angles, it is recommended to use elbows with a large radius for cutting. This way, the arc length is a bit longer. . It’s too short; people will say that the spacing between the welds is too small
I thought with such a small angle, the strength of the cut wound would be…
Please reply with the corresponding floor so that the other party can see it. You can use cold cutting; why do you have to use flame cutting?
Butt welding on straight pipe sections is fine; what pressure level?
For such a large elbow, it’s better to have it custom-made by the manufacturer
Is this something you need to design? Can’t it be purchased?
The main caliber is too large; it’s better to have it customized. For those with a small diameter, cold bending can be used directly