The booster has stopped – how can the re-contact pressure be adjusted?
Thread Content
The reformation booster stopped suddenly, resulting in high pressure at the outlet of the recycle hydrogen compressor; how can it be adjusted in the most optimal and stable manner? ?
Activate the backup unit immediately and adjust the pressure to normal levels
If you come into contact with automatic control again, you won’t need to manage it, as it will adjust itself and eventually reach a stable state; just start the backup unit and ensure that the pressure is adjusted properly
After the booster trips, the pressure is maintained in the system, and each tank retains a certain liquid level to prevent high-pressure hydrogen from entering the low-pressure areas; this helps to maintain the pressure in the higher-pressure tanks, with any excess pressure being released through the higher-pressure vents. The high-pressure bottom oil is diverted to the stabilizer tower. The regeneration system will shut down due to overheating as there is no hydrogen lift. Then, start the standby machine for adjustments.