Reasons for frequent damage of the 3700A card in the TS3000 control system
Thread Content
The 3700A card in the control system of the syngas compressor TS3000 breaks down frequently, and the cause cannot be identified. The signal source has been checked several times with no issues found, and contacting the manufacturer also did not yield any answers. Those of you who have used this equipment: if you have encountered similar problems, please share the reasons for the failures and any solutions you found. Thank you
The points connected to the 3700A should all be isolated by safety barriers, right? This can rule out issues with the site and the cables. Since it still gets damaged, could it be a problem with the card holder’s base plate? It is recommended that the poster try using a different slot and adjust the configuration; after all, frequent failures of the card is a serious problem.