Discussion on smoke extractor descaling technology
Thread Content
What is the scale buildup situation on the flue gas exhaust fans in various factories? Is there any that requires shutdown for 3 months? Are there any good technologies available to address this issue?
Our flue gas exhaust system starts and stops operating in synchronization with the equipment. It has been in use for over 6 years without any shutdowns due to faults with the exhaust system. First of all, when purchasing such a system, it is important to choose a manufacturer whose products are of reliable quality; moreover, it is necessary to control the level of dust in the flue gas at the inlet of the exhaust system
The catalyst dust at the inlet of our exhaust fan is in good condition; it’s probably the structure of the exhaust fan that has a problem. Which company are you from?
1. Catalysts for clogging in turbine blades cannot be determined in just a few words; it represents a problem for companies where clogging is severe. Over the years, analyses, investigations, and efforts to find solutions have been carried out, but components that tend to clog will continue to do so, while those that don’t will remain free from clogging. The same measures may not be applicable in all cases. 2 Our experience: The effects of catalyst fine powder content, the properties of these fine powders, and flue gas moisture on the binder are greater than those of flue gas turbine structure factors
Our experience: The effects of catalyst fine powder content, the properties of these fine powders, and flue gas moisture on the binder are greater than those of flue gas turbine structure factors
But are there any good ways to change these? Only the properties of the catalyst can be specified; it’s difficult to change things like the triple twist and other operating conditions.
The three-spin section can be used to control the speed limit and the flow rate of the fluid; the key is to properly manage the fluid flow issue in the regenerator, addressing any problems as they arise.
There is now a descaling agent imported from the United States; has anyone used it?
I don’t have any say in what others install, but after analyzing various factors with our own system, we accidentally resolved the scaling problem in the smoke extractor – it has been running without issues for almost three years now!
Is your smoke extractor from Lanlian, and is it single-stage? Could you share your successful experiences? Is the cycle three years long, and have there been no issues with the machinery throughout that time?
Which catalyst are you using now? Thank you