Under what circumstances does the inlet pipeline cause the size of the container’s port to increase?
Thread Content
We designed a separator with an inlet pipeline of 4 inches in diameter, and the container’s inlet port is 6 inches in diameter. As for the process design, where was this determined? Are there any relevant standards, or was HYSYS simulation used?~
A higher flow rate causes more severe erosion of the components inside the equipment; check to see if there are any components inside the inlet. I don’t know about other situations
It mainly depends on your requirements for the pressure tassels
I also encountered such confusion during the modeling process and on-site construction; it is a common phenomenon at the senior level
Reduce the flow rate; too high a flow rate is not conducive to separation and absorption. Moreover, high flow rates can likely impact the equipment.