@How can others not see it if it’s there?
Thread Content
I announced the winners of the occupational health and work-related injury case analysis competition in the case analysis summary post, and I @ed them all, but most of them haven’t responded; I’m not sure if they didn’t see it or if they can’t see it. I asked a few people, and only a few of them had seen it.
Was it @ed these past two days, or during the forum debugging a few days ago? And could it be that some step was done incorrectly?
I @ed you in the case analysis summary post under the Health section of the Security area; did you receive that message? In my summary post, I @ed all the winners who had already been announced, but there were very few replies, so I had to inform them one by one.
【Basic Knowledge of Occupational Health】Case Analysis Summary Post http://bbs.hcbbs.com/thread-1562047-1-1.html (Source: Haichuan Chemical Industry Forum)
【Basic Knowledge of Occupational Health】Case Analysis Summary Post http://bbs.hcbbs.com/thread-1562047-1-1.html (Source: Haichuan Chemical Industry Forum)
1. You have @ed too many people (there seems to be a limit on the number). 2. You are editing repeatedly and @ing the same people over and over (could this cause errors?) ) 3. The font for the other person’s username is also set when you @ them. (This seems to have some nuances.) 4. You repeat @mentions in old posts (I’m not sure if @mentions work in old posts). Taken together, these are likely the reasons why your @mentions fail. You can try posting a new thread; if @ doesn’t work, it’s a problem with the forum.
You @ed me, but I didn’t receive it. We’re not friends, so it seems like I can’t receive such messages;P
The company has been quite busy lately; I actually saw the above message a long time ago but didn’t reply. Everything is back to normal now. The original poster is really thorough and hardworking – thank you
I didn’t see it; it’s a good excuse. . .