How to make a timer with ECS700
Thread Content
Is there a time-block module that starts when a pulse signal is given, stops when a stop signal is given, resets when a reset signal is given, and counts time in seconds? The Honeywell DCS has such time blocks; which block is the ECS700 in the central control system? I’m learning on my own and haven’t been able to find it. Please help solve this. Thank you
This post was last edited by lu198734 on 2016-6-17 at 17:39. The TON/TOFF ST timer still has 100ms left. But all of them require a start signal to remain active; if pulse initiation is needed, simply create a function for that. The built-in help files are sufficient for basic learning purposes
In the “Logic Operation Function Block Library,” there is a TIMER function block, which should meet your requirements.