Are there any standards related to jacketed pressure vessels?
Thread Content
I need to construct a mixing tank with a diameter of 4.5 meters in the near future. The pressure inside the tank will be around 20 Kpa, and its volume is approximately 70 cubic meters. I am considering using a jacket for heating; could you advise if there are any relevant standards or drawings that I can refer to?
Is it a full jacket, a semi-tube jacket, or a honeycomb jacket? There are many styles.
Yes, there are many styles available; even for the overall jacket, there is the option of including or not including partitions. If adding them, it is also necessary to decide whether to weld them to the equipment cylinder or to the clamp cylinder; what distance should be left between each layer of partitions, and an exploded view of the partitions is required.
HG/T20569 Mechanical stirring equipment
Jackets are mainly located on the cylinder and the lower head.