Desulfurization and dust removal for 2-ton boilers
Thread Content
Help: Seeking suppliers for desulfurization and dust removal for a 2-ton boiler
In many places nowadays, coal-fired boilers with a capacity of less than 10 tons have been phased out; if the steam demand is low, it is recommended to use gas boilers in the long term.
We can’t just get rid of the small boilers we’re using now... For a corporation with branches in various locations, the cost associated with that would be too high... We originally thought of switching to biomass boilers, but their operating costs are too high； I still want to install desulfurization and dust removal equipment; I’ll give it a try and decide based on the results
Replacing coal boilers with gas boilers is a major trend in environmental protection. Investing in this dust and desulfurization equipment is of little use. It is possible to combine the waste generated by your company – solid waste, wastewater, and exhaust gas – with a set of comprehensive treatment equipment. Such equipment typically includes systems for heat recovery during exhaust gas treatment, thereby achieving both waste treatment and heat reuse.
We are in the feed production industry, and we use small boilers – 2 tons, 4 tons, or even smaller. Many old factories face problems related to the emissions from these small boilers; they either have to shut them down, modify them, or install environmental protection equipment. The ultimate solution is to use gas boilers, but the issue is that many old factories need to be relocated. The authorities don’t want to spend a lot of money; they prefer to solve the problem at a low cost first and then assess the situation. Some factories move directly to industrial areas where there is centralized heating or gas supply, while others simply shut down. So the question is, for a 2-ton boiler, where can I find suppliers for desulfurization and dust removal? !
It’s not possible to do that; how much would it cost to replace it with a gas boiler? The cost of replacing it with a gas boiler is roughly the same as the cost of desulfurization and dust removal
There are basically no boilers with a capacity of 2 tons these days. If desulfurization is necessary, you can check out Shandong Yisheng Environmental Protection; their phone number is 13964344779
It’s still necessary to learn more; the cost of desulfurization and dust removal equipment for 2-ton coal-fired boilers is not low, so investments need to be planned from a long-term perspective.
If it’s convenient, please share a bit more information. I’ll get in touch with some friends who are involved in research at universities to see if it’s possible to carry out pilot tests for biological desulfurization based on your actual conditions. If the cost is acceptable and the results are good, then everyone will be satisfied； On the other hand, at least on this side, there was no intention of making money, and firsthand data was obtained
It is a boiler that generates steam using 2 tons of coal (steam is essential in feed production). What information do you need? The factory is too old; there’s no information left! When upgrading a gas boiler, it is necessary to consider the production costs plus the renovation expenses ； When installing environmental protection equipment, the cost of such equipment is basically taken into consideration ； I do want to change to a biomass fuel stove ；
Now, in many places, high-polluting fuels are restricted, and coal burning is prohibited. It’s best to consult the environmental protection agency first to find out whether coal-fired boilers equipped with environmental protection facilities will be approved for use. If they are approved, a set of desulfurization and dust removal equipment can be installed, and the payment for such equipment should be made only after the environmental compliance check is successful. There are many manufacturers engaged in environmental protection work. I’m not sure which province you’re from