Equipment for peeling wire mesh paste boards
Thread Content
It is a plate-type catalyst whose skeleton is made of 304 stainless steel mesh, with catalyst paste attached to the mesh. It is now necessary to clean the entire unit and scrape off the material attached to it in order to clean it as thoroughly as possible. Is there any equipment that can be used for this purpose? The size of the material sheet is roughly that of A3 paper, or slightly larger, with a thickness of about 1 mm. It has been cleaned, or it has a certain level of humidity (would it be easier to deal with if it were dry?) ). I hope the experts can give some advice. Thank you. (Mechanical equipment, ultrasound, or even more advanced technologies can be considered)
Use chemical or physical cleaning agents according to the material configuration
Cleaning agents cannot solve this issue; a material-based approach is necessary. Please recommend an appropriate method. Thank you