Settler leg issues
Thread Content
The unit is 120 coaxial; it’s not clear when the material legs inside the settler will open once there is a certain amount of catalyst present Also, the instruments show that the amount of material and its density in the leg are both zero; it’s not clear whether these instruments are accurate or not I hope to receive guidance from all the teachers. Thank you!
120: Your material legs should be size 219, right? There are specifications regarding the 2-kilogram opening weight; as for the density of the material legs and the amount of material stored, it’s recommended to remove the pressure introduction pipes – otherwise the material legs will suffer from coking (I’ve experienced this). These two parameters are difficult to control accurately, and they only cause unnecessary problems
Hello, which standard are you referring to? Does it have a name?
I forgot that this forum exists; search for \"wing valve static test\"
It is normal for the density inside the material leg to fluctuate up and down, which indicates that the flap valve is operating properly
Here, the material leg doesn’t show density; there is only a cyclone pressure drop. If this value is low, we consider whether there might be leakage of the material
Are there no instruments for measuring the density and reserve of the material leg?